Up MGTD15470 » Suspension System » Rear Suspension Prev Next Slideshow

Previous image Next image Index page
Back from University Motors-1
rear axle in position
Looking down the axle tube
Rear shackles
Ready to tighten axle to spring-1
  Axle to spring hardware install.JPG - Mounting hardware, axle to spring. An oversized spacer nut, and two locking nuts. I decided to replace the u-bolts with 1/4 inch shorter ones, and use only locking nuts. Those pictures went away with a hard drive failure. I'll take some new ones of the installation.  
LH side of Axle in place on Springs
Axle to spring hardware
Hardened half shaft in place
Split ring & oil seal & hub cover in place
LH side of rear spring and axle

22 | Mounting hardware, axle to spring. An oversized spacer nut, and two locking nuts. I decided to replace the u-bolts with 1/4 inch shorter ones, and use only locking nuts. Those pictures went away with a hard drive failure. I'll take some new ones of the installation. Download
Total images: 39 | Help