MGTD15470 » Gearbox and Clutch » Clutch Refurbishment

email Dave Braun at dave@dbraun99.com (click here)

The clutch had plenty of life, but it made no sense to not replace the disc and pressure plate. I also installed the O'Connor modifications to the clutch fulcrum lever.

1 Clutch engine support brake pedals	2 pressure plate and clutch disc	3 clutch disc smaller end towards engine	4 release lever plate, NA	5 Release Bearing and bell housing
6 oil seal and clutch release fork	7 Relieving clutch release fork taper pin-1	8 Worn bushes	9 Clutch release fork lever	10 Clutch bellcrank lever on engine sump-1
11 bell housing showing oil seal gearbox side	12 Gearbox oil seal	13 Bell housing new bronze bushings	14 Brazed and redrilled hole in clutch release fork lever hole	15 bell housing installed 2
16 Clutch lever fulcrum pin off side-1	17 Clutch lever fulcrum pin on clutch side-1	18 new clutch disc with pressure plate	19 new pressure plate	20 new clutch disk aligned with pilot shart
21 clutch pivot bellcrank before creating relief radii	22 radii filed in Clutch bellcrank with rotary file on drill	23 clutch linkage parts painted	24 clutch rods from bottom	25 close up of clutch fulcrum lever installed
26 fulcrum lever hole relocation	27 fulcrum lever hole relocation 2	28 fulcrum lever ready to install	29 clutch rod after improvement	30 fulcrum lever after improvement installed

30 Images | Create web photo albums with Jalbum | Chameleon skin | Help