Up MGB1970 » Restoration » Electrical » Wiring Slideshow

email Dave Braun at dave@dbraun99.com (click here)

We will be adding a few relays to take the load off some of the switches and deliver more reliable power to the components. We also need to take care of the pesky white wire that the pertronix ignition took out a couple of years ago.

Engine Bay tour 06
Engine Bay tour 07
Engine Bay tour 09
Engine Bay teardown 04
Engine Bay teardown 05
Engine Bay teardown 06
Engine bay teardown 07
Engine bay teardown 08
Engine bay teardown 09
Engine bay teardown 10
Engine bay teardown 11
Trunk Wiring and Grounds 02
Hazard flasher location
Main Tub Ground by wiper motor mount
Door switch wiring 02
Door switch wiring 04
Door switch wiring 05
door switch needs repair
Fuse block and starter relay reinstalled
Odd wire runs tucked into loom 01
Odd wire runs tucked into loom 03
Odd wire runs tucked into loom 04
Odd wire runs tucked into loom 05
Over use of flash to pass switch overheated blue wires close to switch 01
Removing burned ignition wire from harness
Wrapping harness with new tape non sticky
Clamp locations
large bulkhead grommet location
Emergency flasher can and clamp
Ran out of blue tape but progress is good
Repaired and wrapped rire harness 01
Repaired and wrapped rire harness 03
Repaired and wrapped rire harness 04
Threading harness through bulkhead 01
Threading harness through bulkhead 02
Threading harness through bulkhead 03
Initial layout and connections 01
Initial layout and connections 02
Wiring ground prep on inner fender 01
Wiring ground prep on inner fender 02
Wiring main harness to rear harness and clamping harness
Brake function harness clamped
wiring to rear of car, starter, and OD
wiring down under oil cooler hose
Wiring to be done inside car
Dip, Main and Horn relays and bracket drilled and tapped 10-32
Building Dip, Main and Horn relays 01
Building Dip, Main and Horn relays 02
Building Dip, Main and Horn relays 03
Horn relay installation is completely reversible
Installation is completely reversible
Dip, Main and Horn relay power supply is blue
Dip, Main and Horn relays from grille
plastic epoxy on some broken parts 01
plastic epoxy on some broken parts 02
plastic epoxy on some broken parts 03
Underdash wire 01
Underdash wire 02
Wiring panel 01
Wiring panel 02
Wiring panel 03
Orange is power feed for heated seats
second accessory power supply just under dash

63 Images | Create web photo albums and photo books with Jalbum | Chameleon skin | Help