Up MGB1970 » Restoration » Gearbox and Clutch » Gearbox Prev Next Slideshow

Previous image Next image Index page
As removed the bushings face the wrong way no nut at bottom
cutting off the rotten bushes
KY Jelly is going to help
The ring compressor idea didn't work
A vice and a screw dirver to encourage it worked
  Ready to install xrews taped in place for convenience.jpg - If I had this to do over, I would try it with the butterfly bolted to the gearbox via the mounts, and then lever the cross member into place against the stiffness of the mounts.  
close up of shouldered bolt washer and nut
How the factory did it 0
Gearbox installed on engine
Left handed Mike installing speedometoer cable
Found a variety of suggestions on line trying one out

26 | If I had this to do over, I would try it with the butterfly bolted to the gearbox via the mounts, and then lever the cross member into place against the stiffness of the mounts.
« | < | 21 | 22 | 23 | 24 | 25 | 26 | 27 | 28 | 29 | 30 | 31 | 32 | 33 | 34 | 35 | 36 | 37 | 38 | 39 | 40 |
Total images: 40 | Help